1 1

Victron Energy

Victron BlueSolar 30Wp Monocrystalline Solar Panel

Victron BlueSolar 30Wp Monocrystalline Solar Panel

€41,00 EUR
€41,00 EUR
Sale Sold out
Taxes included. Shipping calculated at checkout.

The Victron BlueSolar 30Wp monocrystalline solar panel is a robust glass panel for campers, boats, and other off-grid installations. Its anodized aluminum frame, tempered glass, and bypass diodes make it suitable for fixed mounting in diverse conditions.

  • 30Wp nominal power
  • Monocrystalline solar cells
  • Dimensions: 380 × 450 × 25 mm
  • Weight: 1.8 kg
Why this Victron BlueSolar panel?
  • Good performance in low light and sensitivity across a broad light spectrum.
  • Waterproof junction box and bypass diodes to minimize power loss due to partial shading.
  • Sturdy aluminum frame and tempered glass for fixed mounting.
  • Integrates well with a Victron MPPT charge controller and VictronConnect.

Actual output depends on season, solar irradiation, shading, mounting direction, and battery charge status.

Specifications and dimensions
Power
30Wp
Cell type
Monocrystalline
Vmp
21.2V
Imp
1.42A
Voc
24.7V
Isc
1.49A
Dimensions
380 × 450 × 25 mm
Weight
1.8 kg
What else do you need?
  1. Charge controller: Victron SmartSolar MPPT 75/10 for a single panel on a 12V battery installation.
  2. Solar cable: 4mm², 2 × 5m with connectors.
  3. Battery cable and fuse: 4mm², 2 × 1m with 15A fuse, with the fuse close to the battery or positive busbar.
  4. Roof gland: choose a suitable roof gland for the cable route indoors.
  5. Cable management: use UV and weather-resistant adhesive mounts and cable ties.

Never connect a solar panel directly to the battery. Always use a correctly sized charge controller and protection.

Mounting on a camper, boat, or frame

Camper van: preferably use aluminum Z-brackets on a corrugated or slightly curved metal roof.

Boat: plastic corner mounts are a practical choice on a suitable flat deck.

Flat camper roof: use the Solara ABS spoiler 45 cm white. Preferably position the panel lengthwise on the vehicle, with the short sides front and back, so that the front spoiler guides the driving wind over the panel.

Measure the available space beforehand and consider roof hatches, ventilation, rails, and mounting hardware. Carefully degrease the surface, use suitable construction sealant and primers, and seal all cable entries watertight.

Use with a 24V battery

A single panel does not have sufficient operating voltage for a 24V battery; use multiple panels in series or a higher-voltage panel.

In a 24V system, the same MPPT can handle approximately twice as much solar panel power as with 12V, but only when panel voltage, maximum open-circuit voltage, and wiring are appropriate.

Common mistakes
  • Connecting the panel directly to the battery.
  • Only focusing on wattage and forgetting panel voltage or Voc.
  • Using a cable that is too thin or missing a fuse.
  • Combining panels with different electrical properties without checking.
  • Not accounting for shade, roof obstacles, and space for mounting.
View full details